Energy UNITS FOR LIFT TABLE 1
General Description
This electrical power unit is intended exclusively for your small lift table,Consisting of substantial stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This energy unit is extensively utilised from the industry of logistic units for example minifork lift, scissors lift 
and ariel doing work platforms. The lower-ing motion is managed from the solenoid valve with the pace controlled by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
Standard Description
This electrical power unit is made solely for the medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived from the solenoid valve and the speed controlled through the adjustable needle valve. When the lift rises to a substantial positoin, but the electrical power provide is lower, the decreasing motion is managed through the manual override perform.
Power UNITS FOR LIFT TABLE 3
General Description
This energy unit is intended solely for the big lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve as well as the speed controlled by a stress compensated movement manage valve.
Power UNITS FOR LIFT TABLE four
Standard Description
This electrical power unit is designed solely to the substantial lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve as well as speed managed from the adjustable needle valve. Once the lift rises to a higher positoin, but the power supply is minimize, the lowering movement is managed by the manual override function.
Special Notes
one. This energy unit is of S3 duty cycle, which can only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean every one of the hydraulic parts concerned ahead of set up of the power unit.
3. Viscosity of the oil shoud be 15~46 cst,which should really also be clean and totally free of impurities.N46 hydraulic oil is suggested.
four. Oil changing is needed soon after the first a hundred operation hrs,afterwards once each and every 3000 hrs.
five. The electrical power unit proven is created to be mounted vertically.
