one.A connecting link of an 
O-ring Chain for common application is pre-coated with grease on the pins. Before connection, confirm the grease within the surfaces of pins, and when the quantity of grease is small, apply grease with bare hands. (If gloves are utilised, the grease will be absorbed through the gloves.)
Illustration: When the connecting link (I) of an O-ring chain for basic application is
shipped, O-rings are fitted in the roots of the pins. In the event the O-rings come loose on account of vibration throughout transport, refit the O-rings in towards the roots of the pins.
In this case, be sure you return the grease collected on the roots of your pins for the central surfaces of your pins, a lot more at portion A than at portions B proven within the over illustration. (Portions A is worn due to sliding with the bushings.)
2.The chain could be most very easily linked about the teeth of the sprocket. Engage the back links at the two ends of the chain using the sprocket teeth and fit connecting pins. If your sprocket is often moved, the chain may also be connected on the loosened side.
three. Connecting method
one.Verify that O-rings are attached towards the roots of the pins.
two.In case the level of grease utilized about the connecting pins is little, coat the pins with grease at the central portions.
3.Insert the connecting pins to the bushings in the inner links at each ends.
four.Verify that the grease is utilized for the entire encounter on the O-ring, and fit the O-ring onto the connecting pins.
five.Insert the connecting pins in to the connecting plate and although pressing the connecting plate, set up the spring clip. Verify no matter whether the head (the finish without a split) of the spring clip is turned while in the feeding direction from the chain. (See the next illustration.)
6.Be sure you confirm that the spring clip is securely fitted during the clip grooves on the connecting pins.
This completes jointing on the connecting hyperlink. Note that grease to the surfaces of connecting pins and O-rings is often removed for the duration of installation function. In this case, re-grease utilizing the grease within the surface with the base chain or the grease in the polyethylene bag by which the connecting hyperlink was contained.
